Add event from web source.
![](https://i0.wp.com/lpsystems.eu/wp-content/uploads/2020/04/1-base.png?fit=980%2C531&ssl=1)
- Connect to your Broadcaster page.
![](https://i2.wp.com/lpsystems.eu/wp-content/uploads/2020/04/2-schedule-events-2.png?fit=980%2C531&ssl=1)
2. Open Schedule page and then click on Event.
![](https://i2.wp.com/lpsystems.eu/wp-content/uploads/2020/04/4-accedi-user-e-passw.png?fit=980%2C531&ssl=1)
3. Insert username admin e password lpsystems.
![](https://i2.wp.com/lpsystems.eu/wp-content/uploads/2020/04/5-receiver.png?fit=980%2C531&ssl=1)
4. To add a new event click on the ADD button.
![](https://i1.wp.com/lpsystems.eu/wp-content/uploads/2020/04/7-label-e-primary-address.png?fit=980%2C531&ssl=1)
5. Insert the Label and the Primary address.
Click on Authenticate to insert username and password if required.
NOTE: the address consists of protocol+URI+port+path.
![](https://i1.wp.com/lpsystems.eu/wp-content/uploads/2020/04/8-primary-e-fail-over.png?fit=980%2C531&ssl=1)
6. If needed, you may add backup addresses adding them in the Fail over receivers section.
![](https://i1.wp.com/lpsystems.eu/wp-content/uploads/2020/04/9-opzioni.png?fit=980%2C531&ssl=1)
7. If you use a Nano board, don’t make any change in USB failover, Periodic advertising and Output.
![](https://i1.wp.com/lpsystems.eu/wp-content/uploads/2020/04/10-create.png?fit=980%2C531&ssl=1)
8. Finally click on Create button.
![](https://i1.wp.com/lpsystems.eu/wp-content/uploads/2020/04/11-Saved.png?fit=980%2C531&ssl=1)
9. A Saved message appear appears when the setting has been successful.